Safety Training

Serving Florida since 2009

Overhead Hoist Operator Training @ Safety Solutions and Supply

Start Date: June 2, 2021
End Date: June 2, 2021
Start Time: 8:00 am - 12:00 pm
Location: Mulberry,FL
Venue: Safety Solutions & Supply
Training Size: 10 Students
Cost: $135.00
Instructor: TBD
Register Today

About this Training Course

Safety Solutions and Supply offers OSHA 30, General Industry training authorized by the Occupational Safety and Health Administration. The OSHA 30 is a thirty hour program presented over 4 days which can be provided at our state of the art facility or at your location by our OSHA Training Institute (OTI) certified instructors, based on your training needs. Upon completion all student will receive an official OSHA 30 hour card, approved by the Department of Labor.

The 30-hour General Industry provides training for workers and employers on the recognition, avoidance, abatement and prevention of safety and health hazards in workplaces and includes the following topics:
• Introduction to OSHA
• OSHA Inspection Procedures and Safety Programs
• Recordkeeping
• Hazard Communication
• Exit Route, Emergency Action Plans
• Fire Prevention and Protection
• Electrical
• Flammable and Combustible Liquids

Safety Solutions and Supply is the premier Overhead Hoist training provider. This program is a 4 hour training program, inclusive of hands on learning, practical evaluation and a written assessment.

This program is designed satisfy the training requirements for operators of overhead hoists as defined under CFR 1910.179 and the Crane Manufacturer’s Association of America (CMAA). The program addresses proper operator inspection of cranes, load handling and management, basic rigging methods and techniques.

What does OSHA require for Overhead Hoist training?

Per OSHA 1910.179, employers must use designated personnel to operate overhead cranes and hoists. “Designated” means selected or assigned by the employer or the employer’s representative as being qualified to perform specific duties. Additionally, qualified riggers are required whenever workers are within the fall zone and hooking, unhooking, or guiding a load, or doing the initial connection of a load to a component or structure.

Safety Solutions Training Programs and Facilities:

Safety Solutions and Supply has built a state of the art training center in Mulberry, Florida, located on Highway 60 accessible to both Tampa and Orlando.  Our Gonzales Louisiana Facility is conveniently located right off Interstate 10.  Our state of the art facilities and our subject matter experts will ensure that your employees receive the most current training message and that the message is comprehended with regard to real world situations.  Safety Solutions and Supply’s NCCER ICTP certified instructors will also perform training on specific locations based on your program needs.  Call today to schedule your training.